Specify the WAN port according to the network environment. Click OK.Ĭhoose the menu Transmission > NAT > Virtual Servers and click to load the following page. Enter the IP address and MAC address of PC A. If there is not a desired entry, click to load the following page. Check if the desired IP address is reserved for PC A. Click OK.Ĭhoose the menu Network > LAN > Address Reservation to load the following page. Enable Export to DHCP Address Reservation. In the IP-MAC Binding List section, click to load the following page. In the Scanning Result section, click the corresponding to bind MAC and IP address of PC A.Ĭhoose the menu Firewall > Anti ARP Spoofing > IP-MAC Binding to load the following page. Wait a minute until the scanning is completed. In the general section, specify the scanning IP range according to the DHCP address pool. If the desired entry is in the list, click the corresponding to bind MAC and IP address of PC A.Ĭhoose the menu Firewall > Anti ARP Spoofing > ARP Scanning to load the following page. There are three methods to do IP-MAC binding: bind in the ARP list, bind in ARP scanning result, or add IP-MAC Binding list entry manually.Ĭhoose the menu Firewall > Anti ARP Spoofing > ARP List to load the following page. To achieve this requirement, you can configure the router as follows:Īfter you complete the configuration, you can use a WOL software to wake up PC A on PC B.įollow the steps below to configure the router. Make sure the WAN port of the router is routable from PC B.PC A should be powered off normally and the power supply is normal.In network card properties configuration of PC A, allow the network card to wake up the PC, forbid the PC to turn off the network card to save power, and enable Wake on Magic Packet. Make sure that the network card of PC A supports WOL.In BIOS setup of PC A, enable Power On By PCIE or Wake Up On LAN. Make sure that the motherboard of PC A supports WOL.It is required that PC B can wake up PC A by sending a Magic Packet via the internet.īefore configuring WOL, you should do the following preparation: In the diagram below, PC A is connected to the internet via the router. This will enable WOL automatically rather than you configuring manually.īased on the TechNet Power Management article.You can use WOL (Wake on LAN) to boot up your PC from a remote place by sending a Magic Packet via the internet. If you would like to use a Software package to control Wake on Lan on your Windows PC, grab one of these wake-on-lan software packages (open-source & free) and install on your windows machine as needed. Check the Allow this device to wake the computer checkbox.Select the Power Management tab from the ribbon menu.Right click the network connection (in this case Broadcom NetXtreme Gigabit Ethernet) and click Properties.Click the Change adapter settings link in the left pane.Open the Network and Sharing Center by clicking the Start button and typing "network and sharing", press Enter.To turn Wake-on-Lan on (using Windows 7): Wake-on-Lan can be enabled from the network adapter properties dialog box (after being enabled in BIOS). This command sends a "magic packet" through the specified network interface with the macAddress of the server to wake up. Then run as root: # etherwake -i interface macAddress net-tools on Centos/RHEL (in this case, use the ether-wake command instead of etherwake),.you have to copy the following lines into the /etc/init.d/wakeonlan file as root:įrom another GNU/linux operating system server, to wake up a server via WOL, install the following package:.Running this before shutdown should leave it enabled. ethtool reports all should be working but still no WOL, you may also need to set some paramters for ACPI: To set it up on GNU/Linux operating systems, instructions can be found in the following threads:
0 Comments
Leave a Reply. |